Does the viscosity of hot melt stick affect the quality of glue? The viscosity of the glue will directly affect the quality of the product. Today, Xiaobian will take you to know about the viscosity of the hot melt adhesive stick.

In the actual teaching work, the needle diameter of the spray machine should be 1/2 of the dispensing point diameter. Automatic glue machine technology content is high, but the cost is high!

The viscosity of the glue and the viscosity of the glue directly affect the quality of the glue dispensing machine.

Manual distribution, automatic locking screw machine manual use of the principle of electronic products distribution manual distributor, simple process, low cost, the disadvantage is a waste of labor!

The principle of automatic automatic dispensing machine is to push out the glue with air pressure within a set time.

You can easily change the amount of each injection by pressing the pressure, timing, and choosing the right syringe. So as to ensure the quality of the glue point, improve production efficiency.. In the case of high viscosity, you can reduce the glue point, or even drawing, the viscosity is small, you can increase the glue point, so that the rubber pad leakage glue.. The time of each infusion is controlled by the instrument to ensure the same amount of each infusion.. During the distribution process, the matching pins should be selected according to the size of the pads on the PCB. The same pin should be selected, but different pins should be selected for gaskets with different phase differences.